S36 Security System User Guide

Thank you for purchasing the S36 alarm system. Please read this guide carefully to familiarise yourself with the alarm’s features and operating procedures, and keep it handy for future reference.

Operating Procedure

Complete System Arming

Press the lock button on the vehicle’s original remote control. Arming is confirmed by a siren chirp and a flash of the turn indicators. The system has a 30-second pre-arming delay, indicated by the LED turned on steady.

System Arming with Sensor and Comfort Exclusion

To arm the system while excluding the internal volumetric protection, external (wireless infrared) sensors and the comfort feature, proceed as follows:

1. Make sure the system is disarmed and the ignition key is OFF.
2. Insert the electronic key into its receptacle; the LED will flash quickly.
3. Close the vehicle doors and press the lock button on the original remote control.
4. System activation is confirmed by a low-tone acoustic signal and a flash of the turn indicators.

Exclusion of sensors and the comfort feature is bound to each single arming cycle.

Passive Arming

When passive arming is configured, the system automatically arms approximately 60 seconds after the ignition is switched off and the last door is opened and closed. Activation is confirmed by the standard optical/acoustic signal. With passive arming, internal sensors and comfort output (automatic window roll-up) are excluded. Opening a door during the 60-second countdown interrupts the procedure; it resumes once the door is closed.

Arming Delay

During the 30-second inhibition time after arming (LED on steady), you can exit the vehicle without triggering an alarm.

System Armed

After the delay time, the system is armed and ready to detect any theft attempt. When fully armed, the LED flashes.

Alarm, Inhibit Time and Alarm Cycles

Theft attempts are indicated by acoustic/optical signals. An alarm event can generate up to ten 30-second alarm cycles for each input and each arming cycle, with a 5-second delay between cycles.

System Disarming

Press the unlock button on the vehicle’s original remote control. Disarming is confirmed by 2 siren chirps and 2 flashes of the turn indicators. Five acoustic signals and five flashes warn that an alarm condition occurred prior to disarming (see Alarm Memory for the causes and LED signals).

Emergency Disarming by Electronic Key

This mode is used for emergency disarming (if your remote control is lost or not working) and for total disarming. Touching the electronic key to its receptacle disarms and switches the system off; it will not rearm using the remote control. To restore normal operation, touch the electronic key to its receptacle again: a quick chirp and a flash of the status LED confirm the system has returned to normal operation.

Alarm Memory

Five flashes of the turn indicators and five siren chirps on disarming warn that the alarm was triggered in your absence. To identify the last cause of alarm, turn the ignition key ON and count the status LED flashes. The sequence repeats 3 times; to interrupt it, turn the ignition key OFF.

Warranty Conditions

This product is guaranteed free from manufacturing defects for 24 months from the installation date shown on the warranty, in compliance with Directive 1999/44/CE. Please complete the guarantee certificate included in the booklet and do not remove the guarantee label from the device. The warranty becomes void if labels are missing or torn, if the installation certificate is not fully completed, or if the enclosed sale document is missing. The manufacturer declines any responsibility for malfunctions or damage to the vehicle electrical system due to improper installation, use or tampering. This alarm system is intended solely as a theft-deterrent device.

WEEE Directive

This device does not fall within the scope of Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), as specified in art. 2.1 of L.D. no. 151 of 25/07/2005.

Frequently Asked Questions