Scorpion X-Series Quick Start Guide

These instructions cover the everyday operation of your Scorpion X-Series CAN Bus immobiliser: arming and disarming, Service Mode, and setting or changing your PIN code. Keep your PIN code safe and make a note of it somewhere secure for future use.

Arming & Disarming

• Arm — Turn the ignition OFF and open the door with the ignition OFF: the immobiliser arms (2 indicator blinks).
• Disarm — Turn the ignition ON or start the engine, then enter your PIN code.

Service Mode

Turn the ignition ON and enter your PIN code while holding the last programmed button for 10 seconds (5 indicator blinks). The immobiliser will then allow the vehicle to start normally without the PIN until Service Mode is disabled. Disabling Service Mode is done in the same way as enabling it.

Changing Your PIN Code

To set a new button combination, first enter your previous PIN code, then follow the PIN code setting steps below.

Setting Your PIN Code

Procedure 1

1. With the ignition ON, push the accelerator pedal ten times (if the pedal is supported in your particular vehicle).
2. Press the combination of 1 to 15 supported buttons.
3. Turn the ignition OFF to save the new PIN code. Failing to turn the ignition off within a 5-second window will result in the entered combination being ignored.

Successful entry of a PIN sequence is indicated by the dashboard’s indicator blinking twice. The specific indicator used is shown in the vehicle compatibility list.

Procedure 2

1. With the ignition ON, enter program number 11999 using the switch placed on the PCB.
2. Then complete the remaining steps as in Procedure 1.

Frequently Asked Questions